Introduction Of ZB800-2A Automatic Wall Cement Plastering Machine
Wall Plastering Machine is also known as: Wall finishing machine.
It is a machine specially designed for wall plastering. A hoist
with a vertical gantry and a counter scraper frame is mounted on
the upper surface of the chassis, and a hopper above the chassis
and connected to the chassis is installed inside the two columns of
the scraper frame. The hopper can be slidably attached to the two
columns by the hoisting machine. One side of the gantry is provided
with a discharge opening on the upper façade of the hopper, and a
squeegee is mounted on the lower part of the discharge opening; in
the hopper, along the width direction thereof Supported by a dial
roller, the motor is connected to the dial by a speed reducer, and
the other end of the hopper is provided with a feed port.
1. Automatic Wall Cement Plastering Machine uses the conveyor belt
to transport the plaster forward and upward, can be completely
wiped to the top (1 mm does not stay) with the conveyor belt
completely wiped to the top. The conveyor belt can be manually
stopped or added at any position to achieve the window up and down,
above the doorway Plastering (Note: at least 50cm distance on the
door and window, because the conveyor belt automatically stops at
the top 45cm for the plasterer) can also be filled with plaster
Insufficient to cause secondary smearing after the wall is
ash-deficient, or you can intermittently send plaster to reduce the
floor plaster on the way.
2. Automatic Wall Cement Plastering Machine uses hydraulic
telescopic rods, top and top, can fix the machine in ten seconds,
and the chassis is not forced, the mobile machine only needs to be
released like a jack, the main pole depends The weight is
automatically lifted by the foot, which is the fastest and
3. the width of the wiper is designed according to the doorway of
the suite (80cm). It is 3cm wider than the fuselage and can be
freely entered into the inner and outer houses. The dead angle can
also be easily done.
4. behind the wiper board is equipped with two micro vibrators,
hollow drum and high wall force.
5. The Automatic Wall Cement Plastering Machine is equipped with a
sealed universal wheel that can be easily moved to wherever you
6. completely imitating the artificial design of the artificial.
Parameter Of ZB800-2A Automatic Wall Cement Plastering Machine
|Plastering Height||0-3.6 meters|
|Voltage/frequency||According to your demands|
Photos Of ZB800-2A Automatic Wall Cement Plastering Machine